C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
5. Remove the brake hose retaining clip from the hose mounting bracket.
6. Remove the brake hose bolt and the bracket from the upper control arm.
7. Remove the brake hose bolt and the bracket from the steering knuckle.
8. Remove the brake hose to caliper bolt from the brake caliper.
9. Remove the brake hose from the brake caliper.
10. Remove and discard the 2 copper brake hose gaskets. These gaskets may be stuck to the brake caliper housing or the brake hose end.
Installation Procedure
Important: Install 2 New copper brake hose gaskets.
1. Assemble the 2 New copper brake hose gaskets, and the brake hose bolt to the brake hose.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the brake hose to caliper bolt and 2 New washers to the brake caliper.
Tighten the bolt to 40 Nm (30 ft. lbs.).
Important: The hose must not be twisted. Make sure the hose is not in contact with any suspension component.
