C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
10. Bolt the cable to the differential clips.
Tighten the bolt to 25 Nm (18 ft. lbs.).
Important: After installing the cable to the rear axle holding clip, verify that clip is securely retaining the cable. If not, crimp the clip by hand taking
care not to pinch or kink the cable.
11. Install the cable to the differential clip.
12. Connect the cable to the equalizer.
13. Tighten the nut to the intermediate cable at the equalizer.
Tighten the nut to 3.5 Nm (31 inch lbs.).
14. Remove the safety stands.
15. Lower the vehicle.
16. Adjust the park brake cable.
Park Brake Cable Replacement - Right Rear (With RPO NYS)
Park Brake Cable Replacement - Right Rear (with RPO NYS)
Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Remove the park brake cable from the equalizer by pulling down on the intermediate cable and release the cable from the equalizer bar.
