C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
^
J 8092 Universal Driver Handle - 3/4 inch - 10
^
J 44420 Differential Bearing and Hub Seal Installer
1.
Hold the park brake activation pedal in the FULL upward position.
2.
Pull rearward on the front park brake cable until the pedal drum (2) reaches its full reset position.
3.
Insert a scribe or the shaft of a thin screwdriver (1) on an upward angle through the hole in the front of the pedal assembly, past the retracted pedal
drum, and into the hole in the back of the pedal assembly (3).
4.
Slowly release the cable.
5.
Raise and suitably support the vehicle.
6.
Remove the rear tire and wheels assemblies.
7.
Remove the rear caliper bolts on one side.
8.
Remove the caliper from the rotor (drum-in-hat) and support. Do not leave the caliper hanging from the hydraulic lines.
Note:
Use J 46277 Rotor Removal Tool with J 6125-B Slide Hammer to remove the rotor from the vehicle. Place J 46277 between the rotor surfaces
in the vent section of the rotor. DO NOT place J 46277 on the back side of the rotor surface; it may damage the rotor surface.
9.
For non dual rear wheels: Remove the rear rotor.
For dual rear wheels: Perform Steps 12 through 16 before Step 10.
10.
Repeat Steps 7 through 9 for the other side of the vehicle.
11.
Inspect the parking brake shoe lining thickness in at least 6 places on each side of the vehicle.
11.1. If the lining thickness is less than 1.5 mm (0.06 in) at any spot, install new parking brake shoes on both sides of the vehicle.
^
Non dual rear wheels: Continue to Step 12.
^
Dual rear wheels: Continue to Step 17.
11.2. If the lining thickness is more that 1.5 mm (0.06 in) in all spots, new parking brake shoes are not necessary.
^
Non dual rear wheels: Perform Steps 25 and 26, and then go to Step 38.
^
Dual rear wheels: Continue to Step 25.
