C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
14. Install the generator mounting bracket and bolts.
-
Tighten the generator mounting bracket bolts to 50 Nm (37 ft. lbs.).
15. Install the ribbed idler pulley and bolt.
-
Tighten the idler pulley bolt to 43 Nm (32 ft. lbs.).
16. Install the fuel lines to the fuel injection control module.
17. Connect the wiring harness connector to the fuel injection control module.
18. Install the generator positive cable and the retaining nut to the generator.
-
Tighten the generator positive cable nut to 9 Nm (80 inch lbs.).
19. Connect the generator electrical connector.
20. Install the charged air cooler outlet duct to intake hose.
The hose is marked DUCT, which connects to the charged air cooler outlet duct.
The hose is marked ENG, which connects to the turbocharger.
Align the marks on the hose with the alignment marks on the pipe and duct.
21. Position the clamps as shown for proper clearance.
