C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
8. With the compressor mounted on the J 34992, position the pulley rotor (1) and the bearing assembly on the front head.
9. Position the d 33017 and the J 33023-A directly over the inner race of the bearing.
10. Position the J 8433-1 on the J 33023-A.
11. Assemble the 2 through bolts and the washers through the puller bar slots.
12. Thread the through bolts into the J 34992.
Ensure that the thread of the through bolts engage the full thickness of the J 34992.
13. Tighten the center screw in the J 8433-1 in order to force the pulley rotor and bearing assembly onto the compressor front head.
If the J33017 slips off direct in-line contact with the inner race of the bearing, perform the following steps:
13.1. Loosen the J8433-3.
13.2. Realign the installer and the pilot in order to ensure that the J 33017 properly clears the front head.
14. Use the J 6083 in order to install the following components:
15. The pulley rotor (1)
16. The retaining ring (2)
17. Install the clutch plate and hub assembly.
"For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application ID".
See: Application and ID/RPO Codes
Clutch Rotor and/or Bearing Removal (HT6/HD6/HU6)
TOOLS REQUIRED
-
J 6083 External Snap Ring Pliers
-
J 33023-A Puller Pilot
-
J 41552 Compressor Pulley Puller
-
J 29886 Driver Handle
-
J 9398-A Bearing Remover
