C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
5. Turn the J 41552 clockwise in the slots in the rotor.
6. Perform the following steps in order to remove the pulley rotor and bearing assembly:
6.1. Hold the J41552 in position.
6.2. Tighten the puller screw against the puller guide.
6.3. Remove the pulley rotor and bearing assembly.
7. Mark the clutch coil terminal location (1) on the compressor front head. Refer to Clutch Rotor and/or Bearing Removal (HT6/HD6/HU6).
8. Install the J 33023-A on the front head of the compressor.
9. Install the J8433-1 and the J33025.
10. Tighten the J 8433-3 against the puller pilot in order to remove the clutch coil (2).
"For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application ID".
See: Application and ID/RPO Codes
