C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
1. Install the wire harness block to the junction block.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the retaining bolts.
Tighten
Tighten the bolts to 6 N.m (53 lb in).
3. Install the junction block to the bracket.
4. Push on the top part until it clicks in place.
5. Connect the harness to the front of the junction block.
6. Install the cover to the junction block until it clicks in place.
7. Hand tighten the retaining nut until seated.
