C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
3.
Remove the positive crankcase ventilation (PCV) oil separator cover and gasket.
4.
Drill a 10 mm (25/64 in) hole (1) through the back of the generator bracket. The hole (1) should be located higher than the vent tube (2).
5.
Clean any debris from the oil separator housing.
6.
Install the positive crankcase ventilation (PCV) oil separator cover and a new gasket.
7.
Install the positive crankcase ventilation (PCV) oil separator cover bolts.
Tighten
Tighten the positive crankcase ventilation (PCV) oil separator bolts to 8 N.m (71 in lb).
8.
Install the generator bracket. Refer to Drive Belt Tensioner and Generator Mounting Bracket Replacement.
Parts Information
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warrantv. use the table.
Disclaimer
