C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
1. Position the bracket over the sensor.
2. Install the boost pressure sensor and bracket assembly.
3. Connect vacuum line to boost sensor.
NOTE: Refer to Fastener Notices in Service Precautions.
4. Install the retaining bolt (2).
Tighten
Tighten the bolt to 10 N.m (89 lb in).
5. Connect the electrical connector (1) to the boost pressure sensor.
6. Install the upper intake manifold cover.
7. Install the upper intake manifold cover to the outlet duct.
8. Tighten the outlet duct clamp at the upper intake manifold cover.
Tighten
Tighten the clamp to 6 N.m (53 lb in).