C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
3. Align the PNP switch (5) with the main housing so that the neutral assurance bracket is facing outward.
4. While maintaining the correct PNP switch-to-selector-shaft alignment, slide the new PNP switch (5) over the selector shaft (4).
Notice: Refer to Fastener Notice in Service Precautions.
5. While holding the neutral assurance bracket in engagement with the PNP switch, install the two bolts (6) so that the PNP switch may be rotated
with some effort.
^
Tighten the two bolts (6) to 27 Nm (20 ft. lbs.).
6. Remove and discard the neutral assurance bracket.
Notice:
^
DO NOT drive the selector lever onto the selector shaft.
^
DO NOT use an impact wrench in order to tighten the selector lever nut. Hold the lever with a wrench while tightening the nut.
^
Failure to follow these instructions may result in transmission damage.
Notice: Refer to Transmission Selector Shaft Abuse Notice in Service Precautions.
7. Reinstall shift lever (2). Install nut (3), by hand, on the end of selector shaft (4). Use a wrench (1) to keep the shift lever from rotating.
^
Tighten nut (3) to 24 Nm (18 ft. lbs.).
8. Reconnect the shift selector linkage/cable to the shift lever (2).
9. Connect the external wiring harness to the PNP switch.
