C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
Removal Procedure
Notice: Refer to Power Steering Hose Disconnected Notice in Service Precautions.
1. Remove the power steering inlet hose (2) from the power steering pump (1).
2. Remove the power steering inlet hose (2) from the power steering gear (3).
Installation Procedure
1. Connect the power steering inlet hose (2) to the power steering gear (3).
Notice: Refer to Fastener Notice in Service Precautions.
2. Connect the power steering inlet hose (2) to the power steering pump (1).
^
Tighten the hose connections to 28 Nm (20 ft. lbs.)
3. Bleed the power steering system.
4. Inspect all the hose connections for leaks.
Without Hydroboost
Power Steering Gear Inlet Hose Replacement (Without Hydroboost)
Removal Procedure
