C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the engine protection shield.
Notice: Refer to Power Steering Hose Disconnected Notice in Service Precautions.
3. Install a drain pan under the vehicle.
4. Remove the power steering gear inlet hose (3) from the power steering pump (1).
5. Remove the power steering gear inlet hose from the power steering gear.
6. Remove the power steering gear inlet hose from the vehicle.
Installation Procedure
Notice: Refer to Installing Hoses Without Twists or Bends Notice in Service Precautions.
1. Route the hose in the same position the hose occupied prior to removal.
2. Install the power steering gear inlet hose (3) to the power steering pump (1).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the power steering gear inlet hose to the power steering gear.
^
Tighten the power steering gear inlet hose fittings to 28 Nm (20 ft. lbs.).
4. Remove the drain pan from under the vehicle.
5. Install the engine protection shield.
6. Lower the vehicle.
7. Bleed the power steering system.
