C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
Important:
If reusing the existing sensor, you must align the marks on the flush rotor flange cuff before installation. The alignment mark must stay aligned
until the sensor is seated into the adapter and bearing assembly.
If installing a new sensor, it will come with a pin installed in the sensor. Do not remove the pin until the sensor is seated. If the new sensor did
not come with a pin installed, you must reorder a new sensor.
23.
Looking at the FRONT of the sensor, align the sensor with the steering shaft and install into the adapter and bearing assembly.
24.
Install the connector to the sensor.
Disclaimer
