C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
5. Remove the O-ring seal (3) from the thrust support assembly (2).
Assembly Procedure
Important: Install a new O-ring seal each time the thrust support assembly is removed from the steering gear.
1. Lubricate the new O-ring seal (3).
2. Install the new O-ring seal (3) on the thrust support assembly (2).
3. Install the thrust support assembly (2).
4. Connect the adjuster nut assembly (2) to the steering gear housing (1) using J 42882.
5. Install the coupling shield retainer and the lock nut (1) to the adjuster nut assembly.
6. Refer to Worm Thrust Bearing Preload Adjustment - Off Vehicle (700 Gear) to adjust the thrust bearing preload.
7. Hold the adjuster nut assembly in position to maintain alignment of the marks.
Notice: Refer to Fastener Notice in Service Precautions.
