C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
2.
From the technicians point of view, the FRONT of the sensor (1) connector will be on the right.
Important:
If reusing the existing sensor, you do not have to align the sensor before removal. Centering is not required when it is time to reinstall.
3.
Remove the connector from the sensor.
4.
Remove the sensor (1) from the adapter and bearing assembly.
5.
To install the sensor, proceed to step 1 in the installation section.
6.
From the technicians point of view, the FRONT of the sensor will have:
^
A foam ring (2)
^
A pin hole (1) for centering the pin (note location of the pin hole)
^
A flush rotor flange cuff (4)
Important:
If reusing the existing sensor, you must make an alignment mark on the rotor flange cuff (3) before removing the sensor. Failure to do so will
cause misalignment when installing the sensor. A new sensor will be required if misaligned.
7.
Make an alignment mark on the flush rotor flange cuff (3).
8.
Remove the connector from the sensor.
9.
Remove the sensor from the adapter and bearing assembly.
10.
To install the sensor, proceed to step 5 in the installation section.
