C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
Wheel Bearing: Service and Repair
Front Suspension
Front Wheel Hub, Bearing, and Seal Replacement
Removal Procedure
Notice: Never place vehicle on the ground with the halfshaft removed or the halfshaft nut torqued improperly. Otherwise, bearing seals may become
dislodged causing premature wear and/or damage to the hub and bearing assembly.
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the rotor.
4. Remove the wheel speed sensor and brake hose mounting bracket bolt from the steering knuckle.
5. Remove the wheel hub and bearing (4) 15-series mounting bolts.
6. Remove the wheel hub and bearing mounting bolts (4), the 25/35 series.
7. Remove the wheel hub and bearing and splash shield from the vehicle.
8. Remove the O-ring seal from the steering knuckle bore, the 25/35 series.
9. Remove the wheel speed sensor mounting bolt (5).
10. Clean and inspect the O-ring seal, the 25/35 series.
11. Replace the seal if the following conditions exist:
^
Nicks
^
Cuts
^
Dry or brittle
^
Compression set
Installation Procedure
