C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
2. Slide the installer tool over the output shaft until the seal enters the seal bore. Strike the installer tool with a mallet (1) to drive the seal into the seal
bore. The seal is installed correctly when the shoulder of the installer tool squarely contacts the outer surface of the rear cover.
3. Install the yoke assembly onto the transmission.
Selector Shaft Seal Replacement
Selector Shaft Seal Replacement
^
Tools Required
-
J 43911 Selector Shaft Seal Remover
-
J 43909 Selector Shaft Seal Installer
Removal Procedure
1. Remove the Park/Neutral Position (PNP) Switch.
2. Be sure that the jackscrew for J43911 is backed off and will not interfere with installation of the removal tool. Slide the seal remover tool over the
selector shaft (2) with the threaded end of the tool towards the seal.
3. Rotate the removal tool so that the threads on the end of the tool engage the steel shell (1) of the seal. Use a wrench to be sure that the removal tool
is firmly attached to the seal shell.
4. Rotate the jackscrew in the clockwise direction to remove the seal from the bore. Discard the seal that was removed.
Installation Procedure
