C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
1. Lubricate the converter pump hub OD and the torque converter seal with clean transmission fluid.
2. Use the three-strand sling (1) to lower the torque converter (2) over the turbine shaft and ground sleeve. Remove the three-strand sling.
3. Spin the torque converter to engage the turbine shaft splines in the torque converter hub, the ground sleeve splines in the stator race and to engage
the drive flats on the converter pump hub with the oil pump drive gear.
4. The torque converter is correctly installed when the same measurement taken in the removal procedure is obtained.
5. Install the J 21366 Converter Holding Strap.
6. Reinstall the transmission into the vehicle.