C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
4. Using the following procedures replace the ring gear on the flywheel:
4.1.
Heat the ring gear evenly with a torch. Do not overheat.
4.2.
Using a hammer and punch remove the ring gear.
Installation Procedure
1. Replace the ring gear, if removed.
Important: When heating the ring gear with a torch do not overheat. Do not get the ring gear so hot that it turns blue or red.
1.1.
Heat the ring gear evenly with a torch.
1.2.
Using a hammer and a brass punch install the ring gear until seated.
2. Install the pilot bearing in the flywheel.
