C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
4. Position the J41364-A onto the PNP switch. Ensure that the two slots on the switch where the manual shaft is inserted are lined up with the lower
two tabs on the tool.
Notice: Refer to Fastener Notice in Service Precautions.
5. Rotate the tool until the upper locator pin on the tool is lined up with the slot on the top of the switch.
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
6. Remove the J41364-A from the PNP switch. If installing a NEW switch, remove the positive assurance bracket at this time.
7. Connect the PNP switch electrical connectors.
8. Install the transmission control lever to the manual shaft with the nut.
^
Tighten the nut to 25 Nm (18 ft. lbs.).
9. If equipped with 4WD, install the front propeller shaft.
10. Check the PNP switch for proper operation. The engine must start in the P (Park) or N (Neutral) positions ONLY. If proper operation of the switch
can not be obtained, replace the switch.
