C 3500 Truck 2WD V8-8.1L VIN G (2001)
Important: Complete the following steps ONLY if the seat is equipped with a lumbar support.
*
Insert the lumbar adjuster cable into the slot in the assembly.
*
Turn the threaded black end of the assembly until the slot retaining the cable is concealed.
*
Install the 2 screws retaining the lumbar cable assembly to the seat cushion frame.
Install the seat cushion frame (3) to the seat assembly.
Notice: Refer to Fastener Notice in Service Precautions.
Important: Install the bolts in the original locations.
2. Install the 2 bolts retaining the seat back recliner (5) to the seat cushion frame (3).
Tighten the bolts to 30 N.m (22 lb ft).
Important: Install the bolts in the original locations.
3. Install the 2 bolts retaining the seat back hinge to the seat cushion frame (3).
Tighten the bolts to 30 N.m (22 lb ft).
4. Install the seat cushion pad.
5. Install the seat to the riser (2).
