C 3500 Truck 2WD V8-8.1L VIN G (2001)
1. Install the relay rod (9) to the vehicle.
2. Install the relay rod (9) to the pitman arm ball stud (2).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the relay rod (9) to the idler arm ball stud (1). Ensure the seal is on the stud.
4. Install the J291930r the J2.9194.
5. Tighten the steering linkage installer in order to seat the tapers.
-
Tighten the steering linkage installer to 54 Nm (40 ft. lbs.).
6. Remove the J 29193 or the J 29194.
7. Install the new pitman arm prevailing torque nut.
8. Install the new idler arm prevailing torque nut.
-
Tighten the nuts to 62 Nm (46 ft. lbs.).
9. Install the tie rod ends. Refer to Tie Rod Replacement.
10. Install the steering dampener to the relay rod, if equipped. Refer to Steering Damper Replacement.
11. Install the engine protection shield, if equipped. Refer to Engine Protection Shield Replacement in Body and Frame.
12. Lower the vehicle.
13. Check the wheel alignment. Refer to Measuring Wheel Alignment.
