C 3500 Truck 2WD V8-8.1L VIN G (2001)
humidity. Allow at least 24 hours for the complete curing of the urethane adhesive.
*
For the chemical-curing type of urethane adhesive, allow a minimum of 1 hour.
Do NOT physically disturb the repair area until after these minimum times have elapsed.
The following conditions must be maintained to properly cure the urethane:
1. Partially lower a door window in order to prevent pressure buildups when closing doors before the urethane adhesive cures.
2. Do not drive the vehicle until the urethane adhesive is cured. Refer to the above curing times.
3. Do not use compressed air in order to dry the urethane adhesive.
40. Connect the electrical connector to the rear window defogger on the rear window, if equipped.
41. Install the rear window garnish lower molding.
42. Raise seat back.
43. Remove the protective coverings and tape from the vehicle rear and headliner.
44. Close the rear window.
