C Yukon 2WD V8-5.7L VIN R (1999)
2. Center punch (5) each bolt hole location on the body hinge pillar and/or on the door.
3. Drill a 13.0 mm (0.51 in) hinge attaching hole (3) in 3 steps in order to assure the proper placement of the hinge.
4. Prepare the surface for the replacement hinges using a file or a similar tool.
5. Coat the mating surfaces of the hinges with a medium-bodied sealer.
6. Install the hinges, the backing plate, the bolts, and the nuts by completing the following steps:
6.1.
Align the hinge, the pillar, and/or the door with the holes in the hinge pillar and the door.
6.2.
Place the bolts through the hinge, the pillar and/or the door, and the backing plate.
NOTE: Refer to Fastener Notice in Service Precautions.
6.3.
Install the nuts.
Tighten
Tighten the nuts to 35 N.m (26 lb ft).
7. Install the door to the body. Door Replacement - Rear.
8. Install the lock-pillar trim panel.
9. Adjust the door. Refer to Door adjustment
10. Apply sealer around the hinges.
