C Yukon 2WD V8-5.7L VIN R (1999)
8. Remove two 11 mm splash shield mounting bolts.
9. Remove wheel speed sensor and splash shield assembly (10).
10. Remove splash shield gasket.
11. Clean gasket and knuckle (12) surfaces thoroughly with a dry cloth.
INSTALLATION PROCEDURE
1. Install splash shield gasket.
2. Install wheel speed sensor splash shield.
3. Install two 11 mm splash shield mounting bolts.
^
Tighten the splash shield mounting bolts to 16 Nm (12 ft. lbs.)
^
Tighten the speed sensor mounting bolts to 26 Nm (19 ft. lbs.)
4. Install harness clips (4), fastening bolts and nuts (5) to the frame attachment points.
5. Install the hub and rotor.
6. Install brake caliper.
7. Install tire and wheel.
