C Yukon 2WD V8-5.7L VIN R (1999)
8. Measure the clearance between the caliper and the bracket stops.
^
If necessary, remove the caliper and file the ends of the bracket to obtain a 0.26 to 0.60 mm (0.010 to 0.024 inch) total clearance.
^
Measure the clearances individually and then add them together.
^
Install the tire and the wheel.
IMPORTANT: Pump the brake pedal until it is firm before moving the vehicle. Check the fluid level in the master cylinder after pumping the
brakes.
Brake Caliper Replacement (Rear)
REMOVAL PROCEDURE
1. Remove two-thirds of the brake fluid from the master cylinder.
2. Raise the vehicle.
3. Support the vehicle with safety stands.
4. Mark the relationship between the wheel and the hub.
5. Remove the tire and the wheel assembly.
6. Position a C-clamp and tighten it until the piston bottoms in the bore.
7. Remove the C-clamp.
8. Remove the brake hose.
