C Yukon 2WD V8-5.7L VIN R (1999)
^
Make sure all of the parts are clean and free of grease.
^
Apply an approved high-temperature front wheel bearing grease to the spindle at the inner and outer bearing seat, the shoulder, and the seal
seat.
^
Also, finger apply a small amount of grease inboard of each bearing cup in the hub/rotor.
^
Pressure pack the bearings with a greasing machine, or hand pack the bearings. Make sure the grease is worked thoroughly into the rollers, the
cone, and the cage.
2. Apply and additional quantity of grease outboard of the inner bearing.
3. Install the seal.
3.1. Lubricate the seal lip.
3.2. Use a seal installation tool or a flat block in order to press the seal down flush with the hub.
3.3. Seat the outer bearing and the cup.
4. install the hub/rotor to the spindle.
Important: Do not scuff the spindle threads.
5. Install the outer bearing to the hub/rotor.
6. Install the washer.
7. Install the nut.
7.1. Tighten the nut to 16 Nm (12 ft. lbs.), while turning the wheel assembly forward by hand.
7.2. Apply grease to the outboard side of the outer bearing.
Notice: Refer to Fastener Notice in Service Precautions.
Important: Adjust the wheel bearings. Refer to Wheel Bearing Adjustment.
8. Install the brake caliper. Refer to the Brake Caliper Service and Repair Procedure. See: Brake Caliper/Service and Repair
