C Yukon 2WD V8-5.7L VIN R (1999)
Power Steering Fluid Cooler: Service and Repair
Frame Mounted Power Steering Cooler
REMOVAL PROCEDURE
1. Install a drain pan under the vehicle.
2. Siphon the power steering fluid from the reservoir to prevent excessive spillage.
3. Remove the power steering cooler (6) from the power steering gear.
Notice: Do not start the vehicle with any power steering gear inlet or outlet hoses disconnected. When disconnected, plug or cap all openings of
components. Failure to do so could result in contamination or loss of power steering fluid and damage to the system.
4. Remove the power steering cooler (6) from the power steering pump.
5. Remove the front bumper.
6. Remove the front center filler panel.
7. Raise the vehicle.
Notice: The inlet and outlet hoses must not be twisted during installation. Do not bend or distort the inlet or outlet hoses to make installation
easier. Failure to follow these procedures could result in component damage.
