C Yukon 2WD V8-5.7L VIN R (1999)
Front Steering Knuckle: Service and Repair
REMOVAL PROCEDURE
-
Tools Required
-
J 23742 Ball Joint Separator
1. Raise the front of the vehicle.
-
Place safety stands under the front lift points.
-
Do not place floor stands under the lower control arms because spring tension is needed to assist in breaking loose the ball joint studs.
2. Remove the tire and wheel assembly.
3. Remove the brake caliper.
Notice: Support the caliper with a piece of wire to prevent damage to the brake line.
4. Remove the hub/rotor assembly.
5. Remove the three bolts that attach the splash shield to the knuckle.
6. Remove the knuckle seal if the knuckle is to be replaced. Do not damage the knuckle seal.
