Canyon 2WD L4-2.9L (2008)
Installation Procedure
1. Warm the body surface with a heat gun 152 mm (6 in) from the surface to a minimum of 21°C (70°F).
2. Remove the backing from the wedge (1).
3. Align the tabs on the wedge to the holes in the body.
4. Press the wedge to the body surface.
5. Inspect the wedge for proper adhesion.
6. Remove the tape from the area around the wedge.
7. Close the rear side access door.
Rear Side Door Wedge Replacement - Door Side
Rear Side Door Wedge Replacement - Door Side
Removal Procedure
