Canyon 2WD L4-2.9L (2008)
Important: When installing the brake hose or brake line fittings, always finger-tighten the fitting before tightening to specification.
6. Install the left brake line to the brake hose.
Tighten the fitting to 19 N.m (14 lb ft).
7. Remove the rubber cap or plug from the right brake line.
Important: When installing the brake hose or brake line fittings, always finger-tighten the fitting before tightening to specification.
8. Install the right brake line to the brake hose.
Tighten the fitting to 19 N.m (14 lb ft).
9. Fill the master cylinder reservoir, if needed. Refer to Master Cylinder Reservoir Filling (See: Brake Master Cylinder/Service and
Repair/Procedures/Master Cylinder Reservoir Filling) .
10. Bleed the brake system. Refer to Hydraulic Brake System Bleeding (Manual) (See: Brake Bleeding/Service and Repair)Hydraulic Brake System
