Canyon 2WD L4-2.9L (2008)
4. Swing the arm over the valve spring retainer and tighten the swivel nut of the J-44228-A down only enough to allow access for installation of the
valve locks.
5. Position the valve locks to the valve stem retainer groove using the J 43059.
6. Remove the swivel nut and arm of the J-44228-A
7. Install the arm and swivel nut of the J-44228-A over the stud of any other valves being serviced for this cylinder and repeat removal steps 11
through 16 and installation steps 1 through 7.
8. Relieve the air pressure to the cylinder being serviced.
9. Remove the J 39313 from the spark plug hole.
10. Remove the base plate of the J-44228-A.
11. Repeat removal steps 7 through 16 and installation steps 1 through 10 on any other cylinders being serviced.
12. Install the spark plugs. Refer to Spark Plug Replacement (See: Tune-up and Engine Performance Checks/Spark Plug/Service and Repair).
13. Install the camshafts. Refer to Camshaft Replacement (See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair).
14. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
15. Remove the EN 46547 (1) from the flywheel teeth.
