Canyon 2WD L4-2.9L (2008)
10. Remove the upper 2 bolts securing the engine wiring harness bracket to the intake manifold.
11. Raise and support the vehicle only high enough to access the remaining components through the wheelhouse. Refer to Lifting and Jacking the
Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
12. Remove the left front wheel. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
13. Remove the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (See: Body and Frame/Fender/Front Fender/Front Fender
Liner/Service and Repair).
14. Disconnect the following wiring harness retainers from the engine wiring harness bracket:
*
The battery cable
*
The engine (4, 6)
*
The MAP sensor (5)