Canyon 2WD L4-2.9L (2008)
Balance Shaft Chain Tensioner: Service and Repair
Balance Chain Tensioner Replacement
Removal Procedure
1. Remove the crankshaft rear oil seal housing. Refer to Crankshaft Rear Oil Seal and Housing Replacement (See: Cylinder Block
Assembly/Crankshaft Seal Retainer/Service and Repair).
Important: Every 11-crankshaft rotations, 3 of the 5 dark links on the timing chain will line up with the timing marks.
2. Rotate the crankshaft until the correct timing chain and timing marks align:
*
The left-hand balance shaft sprocket timing mark (1) is at the 12:00 position.
*
The right-hand balance shaft sprocket timing mark (2) is at the 2:30 position.
*
The crankshaft sprocket timing mark (3) is at the 4:30 position.
*
The 3 timing marks (1-3) on the sprockets line up with a dark link on the chain.
