Canyon 2WD L4-2.9L (2008)
8. Remove and discard the exhaust camshaft position actuator bolt.
9. Remove the exhaust camshaft position actuator.
Installation Procedure
1. Ensure the camshaft actuator is fully advanced prior to installation.
2. Install the exhaust camshaft actuator into the timing chain.
Aligning the marked link (1) on the timing chain with the timing mark (1) on the exhaust camshaft position actuator sprocket.
Important:
*
To aid in aligning the actuator to the camshaft, use a 25 mm (1 in) wrench on the hex of the camshaft to rotate.
*
Ensure the alignment pin is properly engaged with the camshaft.
3. Install the exhaust camshaft actuator onto the exhaust camshaft.