Canyon 2WD L4-2.9L (2008)
License Plate Bulb: Service and Repair
License Lamp Bulb Replacement
Removal Procedure
1. Ensure the headlamp switch is in the OFF position.
2. Disconnect the electrical connector (2) from the license lamp assembly (1).
3. Remove the nut (3) retaining the license lamp to the bumper.
4. Remove the license lamp assembly from the bumper.
5. Twist the lamp socket counterclockwise to remove.
6. Remove the bulb.
Installation Procedure
1. Install the bulb to the lamp socket.
2. Twist the lamp socket clockwise to install.
3. Install the lamp assembly (1) into the bumper.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
4. Install the license lamp nut (3).
Tighten the nut to 2.5 N.m (22 lb in).
5. Install the electrical connector (2).
6. Inspect the lamp operation.