Canyon 2WD L4-2.9L (2008)
Control Arm Bushing: Service and Repair
Front Lower Control Arm Bushing Replacement
Tools Required
J 41805 Ball Joint Remover/Installer
Removal Procedure
1. Remove the front drive axle, if equipped. Refer to Differential Carrier Assembly Replacement () .
2. Remove the lower control arm. Refer to Lower Control Arm Replacement (2WD, Z85, ZQ8) (See: Service and Repair/Lower Control Arm
Replacement (2WD, Z85, ZQ8)) .
3. Before removing the bushing, measure and record the distance from the bushing flange to the bracket. This will be the distance that the new
bushing will be installed to.
