Canyon 2WD L4-2.9L (2008)
Pilot Bearing: Service and Repair
Clutch Pilot Bearing Replacement
Tools Required
*
J 43276 Clutch Pilot Bearing Remover
*
J 45949 Pilot Bearing and Flywheel Locator Installer
Removal Procedure
Notice: When using the J 43276 Clutch Pilot Bearing Remover, always secure the J 43276-1 Clutch Pilot Bearing Remover tool body using a wrench.
Do not allow the J 43276-1 tool body to rotate. Failing to do so causes damage to the J 43276-1 tool body.
1. Remove the Flywheel. Refer to Engine Flywheel Replacement (with Manual Transmission) (See: Flywheel/Service and Repair)Engine Flywheel
Replacement (with Automatic Transmission) (See: Flex Plate/Service and Repair) for the 2.9L engine or Engine Flywheel Replacement (with
Automatic Transmission) (See: Flex Plate/Service and Repair)Engine Flywheel Replacement (with Manual Transmission) (See: Flywheel/Service
and Repair) for the 3.7L engine.
2. Using the J 43276 perform the following in order to remove the clutch pilot bearing:
1. Install the J 43276-1 into the clutch pilot bearing.
2. Using a wrench, secure the J 43276-1.
3. Insert the J 43276-2 into the J 43276-1.
4. Rotate the J 43276-2 clockwise into the J 43276-1 until the clutch pilot bearing is completely removed from the crankshaft.
5. Rotate the J 43276-2 counterclockwise to remove the J 43276-2 from the J 43276-1.
6. Remove the J 43276-1 from the tool body.
3. Discard the old clutch pilot bearing.
Installation Procedure
