Canyon 2WD L5-3.5L VIN 6 (2004)
Rear Door Window Regulator: Service and Repair
Window Regulator Replacement - Rear Door
Manual window regulator (without A31) shown, power regulator (A31) similar.
Removal Procedure
1. Remove the rear door trim panel.
2. Remove the rear inside door handle.
3. Remove the rear door speaker.
4. Remove the rear door water deflector.
5. Remove the bolts retaining the rear window to the window regulator.
6. Raise and support the rear door window.
7. Disconnect the electrical connector from the window regulator motor, if equipped with A31.
8. Loosen the bolts retaining the window regulator (1) to the inner door at the keyhole slot (2) locations.
9. Remove the bolts retaining the window regulator to the inner panel.
10. Remove the window regulator (1) by lifting the regulator up, and out of the keyhole slots (2) in the inner panel, and removing the regulator out
through the access hole.
Installation Procedure