Canyon 2WD L5-3.5L VIN 6 (2004)
Trim Panel: Service and Repair
Garnish Molding Replacement
GARNISH MOLDING REPLACEMENT - WINDSHIELD PILLAR
REMOVAL PROCEDURE
1. Remove the bolt cover (1) using a flat-bladed plastic tool.
2. Remove the windshield garnish molding bolt (3) securing the molding to the pillar.
3. Remove the windshield garnish molding by pulling the molding away from the pillar.
INSTALLATION PROCEDURE
1. Position the windshield garnish molding on the pillar.
2. Install the molding by firmly pressing the molding against the pillar to seat the fasteners (2).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the windshield garnish molding bolt (3).
Tighten
Tighten the bolt to 9 N.m (79 lb in).
4. Install the bolt cover (1).
Garnish Molding Replacement - Windshield Pillar