Canyon 2WD L5-3.5L VIN 6 (2004)
Seat Heater: Description and Operation
HEATED SEATS DESCRIPTION AND OPERATION
HEATED SEATS SYSTEM OPERATION
The driver and front passenger seats are heated using electric heater elements located in the seat cushions and seat backs. The heated seat control
module is part of the seat cushion element and harness assembly, and controls the battery positive voltage used to supply the seat heater elements. The
heated seat switch and a thermistor located in the seat cushion are connected in series and provide a single input to the heated seat control module.
Ignition voltage is supplied to the heated seat switch from the HVAC 20A fuse in the underhood BEC. When the heated seat switch is in the high or
low positions voltage is supplied through one of the internal resistors to the switch signal circuit. The heated seat switch signal circuit is grounded
through the seat cushion thermistor which is a temperature sensitive variable resistor. The heated seat switch signal circuit input to the heated seat
control module is spliced from the circuit between the switch and the thermistor, where the voltage level is determined by the resistance of both
components. When the heated seat switch signal circuit input to the heated seat control module is within a specified voltage range, the control module
closes the battery voltage circuit to the heater element supply circuit. The passenger heated seat switch must be enabled through the seat belt switch in
order for heated seat operation to occur.
