Canyon 2WD L5-3.5L VIN 6 (2004)
Brake Hose/Line: Service and Repair
Brake Pipe Replacement
Brake Pipe Replacement
Removal Procedure
^
Tools Required
-
J 45405 Brake Pipe Flaring Kit
Caution: Refer to Brake Fluid Irritant Caution in Service Precautions.
Caution: Always use double walled steel brake pipe when replacing brake pipes. The use of any other pipe is not recommended and may cause brake
system failure. Carefully route and retain replacement brake pipes. Always use the correct fasteners and the original location for replacement brake
pipes. Failure to properly route and retain brake pipes may cause damage to the brake pipes and cause brake system failure.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Component Notice in Service Precautions.
Important When servicing the brake pipes, note the following:
^
If sectioning the brake pipe, use replacement pipe of the same type and outside diameter.
^
Use fittings of the appropriate size and type.
^
Only create flares of the same type or design as originally equipped on the vehicle.
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Using a backup wrench, remove the brake pipe from the junction block. Left side shown, right side similar.
3. Remove the right brake pipe from the axle housing retainer.
