Canyon 2WD L5-3.5L VIN 6 (2004)
Balance Shaft: Service and Repair
Right
Balance Shaft Replacement-Right
Removal Procedure
1. Remove the balance shaft drive chain.
Important:
^
Do not disassemble the balance shaft assembly. Remove and install the balance shaft as a complete assembly.
^
Rotate the balance shaft to check for free rotation. If the balance shaft does not turn free, inspect the balance shaft bearings and bearing surface for
damage.
2. Remove the right balance shaft retaining bolts. Discard the bolts.
3. Remove the right balance shaft assembly.
Installation Procedure
1. Lubricate the balance shaft bearing journals with clean engine oil.
2. Install the right balance shaft assembly with the counterweight down to prevent damage to the balance shaft bearings.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the new balance shaft retaining bolts.
^
Tighten the balance shaft retaining bolts to 12 Nm (106 inch lbs.).
4. Install the balance shaft drive chain.