Canyon 2WD L5-3.5L VIN 6 (2004)
4. Swing the arm over the valve spring retainer and tighten the swivel nut of the J 44228 down only enough to allow access for installation of the
valve locks.
5. Position the valve locks to the valve stem retainer groove using the J 43059.
6. Remove the swivel nut and arm of the J 44228
7. Install the arm and swivel nut of the J 44228 over the stud of any other valves being serviced for this cylinder and repeat removal steps 11 through
16 and installation steps 1 through 7.
8. Relieve the air pressure to the cylinder being serviced.
9. Remove the J 39313 from the spark plug hole.
10. Remove the base plate of the J 44228.
11. Repeat removal steps 7 through 16 and installation steps 1 through 10 on any other cylinders being serviced.
12. Install the spark plugs.
13. Install the valve rocker arms.
14. Raise and support the vehicle.
15. Remove the EN 46547 (1) from the flywheel teeth.
16. Install the service slot plug.
