Canyon 2WD L5-3.5L VIN 6 (2004)
6. Notice: Refer to Fastener Notice in Service Precautions.
Install the new intake camshaft sprocket bolt.
A. Tighten the intake camshaft sprocket bolt to 20 Nm (15 ft. lbs.).
B. Use the J 45059 to rotate the intake camshaft sprocket bolt an additional 100 degrees.
7. Ensure the camshaft actuator is fully advanced prior to installation.
8. Install the exhaust camshaft actuator into the timing chain. Aligning the dark link (1) of the timing chain with the timing mark (1) on the exhaust
camshaft position actuator sprocket.
9. Notice: The camshaft actuator must be fully advanced during installation. Engine damage may occur if the camshaft actuator is not fully
advanced.
Important:
^
To aid in aligning the actuator to the camshaft, use a 25 mm (1 inch) wrench on the hex of the camshaft to rotate
^
Ensure the alignment pin is properly engaged with the camshaft
Install the exhaust camshaft actuator onto the exhaust camshaft.
