Canyon 2WD L5-3.5L VIN 6 (2004)
6. Remove the CPA from the I/P module yellow 4-way connector located under the I/P module.
7. Disconnect the I/P module yellow 4-way connector located under the I/P module.
ENABLING PROCEDURE
1. Remove the key from the ignition.
2. Connect the I/P module yellow 4-way connector located under the I/P module.
3. Install the CPA to the I/P module yellow 4-way connector located under the I/P module.
4. Install the SIR fuse to the fuse block (1) located in the underhood fuse block.
5. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
5.1.
The AIR BAG indicator will flash 7 times.
5.2.
The AIR BAG indicator will then turn OFF.
6. Perform the Diagnostic System Check - Restraint Systems if the AIR BAG indicator does not operate as described.
