Canyon 2WD L5-3.5L VIN 6 (2004)
17. Remove the CPA from the I/P module yellow 4-way connector located under the I/P module.
18. Disconnect the I/P module yellow 4-way connector located under the I/P module.
19. Remove the left door trim panel.
20. Remove the connector position assurance (CPA) (3) from the side impact sensor yellow 2-way connector (5) located near the middle of the door.
21. Disconnect the side impact sensor yellow 2-way connector (5) located near the middle of the door.
22. Remove the trim panel.
23. Remove the connector positive assurance (CPA) from the seat belt pretensioner-right connector.
24. Disconnect the seat belt pretensioner-right connector from the vehicle harness connector.
25. Remove the garnish molding.
