Canyon 2WD L5-3.5L VIN 6 (2004)
5. Remove the speed sensor bracket from the upper control arm.
Important: Mark the holes used to mount the speed sensor electrical connector before removing. This will ensure the proper location of the speed
sensor electrical connector for installation.
6. Remove the speed sensor electrical connector from the body.
Important: The following service procedure is to ensure that the speed sensor wiring harness is properly positioned so that the length of the wiring
harness is correct for installation. Failure to do so could cause damage to the speed sensor wiring harness.
7. Using white or bright colored paint, mark the location of the speed sensor wiring harness to the steering knuckle.
