Canyon 2WD L5-3.5L VIN 6 (2004)
12. Remove the wheel bearing/hub from the brake rotor.
13. Clean the contact area between the wheel bearing/hub and the brake rotor.
Installation Procedure
1. If Necessary, install a new wheel speed sensor on the bearing hub.
2. Position the wheel bearing/hub assembly on the brake rotor.
3. Install the mounting bolts from the wheel bearing/hub assembly to the brake rotor.
Notice: Refer to Fastener Notice in Service Precautions.
Important: The following service procedure is to be performed on a flat surface and to ensure that the brake rotor is securely attached to the hub
assembly prior to the final torquing procedure. DO NOT use air tools of any type for this procedure.
4. Tighten the bolts in crisscross pattern.
Tighten
Tighten the mounting bolts to 20 Nm (15 lb ft).
5. Install the backing plate to the wheel bearing/hub, brake rotor assembly.
