Canyon 2WD L5-3.5L VIN 6 (2004)
Fluid Line/Hose: Service and Repair
Transmission Fluid Cooler Hose/Pipe Replacement
Removal Procedure
1. Raise the vehicle.
2. Disconnect the transmission fluid cooler lines from the radiator.
3. Remove the transmission fluid cooler lines from the retainer located on the radiator.
4. Remove the transmission fluid cooler lines from the retainer located on the right side of the engine.
5. Support the transmission with a transmission jack.
6. Remove the transmission support.
7. Remove the front exhaust pipe assembly.
8. Carefully lower the transmission to gain access to the transmission fluid cooler line fittings.
9. Disconnect the transmission fluid cooler lines from the transmission.
10. Remove the transmission fluid cooler lines from the vehicle.
Installation Procedure
1. Install the transmission fluid cooler lines to the vehicle.
2. Install the transmission fluid cooler lines to the transmission.
Notice: Ensure that the cooler line being installed has a plastic cap on each end that connects to a quick connect fitting. If no plastic cap exists, or the
plastic cap is damaged, obtain a new plastic cap and position on to the cooler line prior to the cooler line installation.
3. Raise the transmission into position.
4. Install the front exhaust pipe assembly.
5. Install the transmission support.
6. Remove the transmission jack.
7. Install the clip (2) that holds the transmission fluid cooler lines together.
8. Install the transmission fluid cooler lines to the right side of the engine.
9. Install the transmission fluid cooler line to the retainer located on the radiator.
10. Install the transmission fluid cooler lines to the radiator.
11. Lower the vehicle.
12. Fill the transmission to the proper level with DEXRON III transmission fluid.
